E3 gate valve, System 2000 with mounted PE ends I PN 16

• Double bayonet O-ring carrier is connecting the spindle to the bonnet, allowing a fully encased, uniform epoxy powder coated bonnet for further improved corrosion protection
• Wedge guide made of wear resistant POM material in load optimized design minimizes attrition and ensures lowest torque actuation
• Wedge is flexible and fully linked in vulcanized elastomer to the wedge nut. This snug fit dampens vibration during opening and closing of the wedge
• Wedge nut has a long thread length allowing significantly higher torques than the standard before breaking
• O-rings, lip-seals mounted in the bonnet are replaceable under operating pressure
• Extended edge protection to avoid damages during transport, storage and assembly
• Sliding disks and ball bearing assure low friction performance of the spindle
• 100% suitable for buried installations

• Resilient seated gate valve with smooth straight-through bore
• With PE ends for welding on to PE pipes, factory-mounted into the restraint sockets and tested
• Duplex stainless steel spindle

• One extension spindle for several dimensions
• Suitable for operation by automatic actuators
• Easy retrofitting for position indicator and automatic actuator on the standard bonnet (DN 50 to DN 200)
  To set-up an actuator or a position indicator, remove the centering flange and insert position indicator or actuator with adapter (DN 250 to DN 350)

Standard version: without handwheel and extension spindle
Special versions: on request