Pipe repair clamp "TOL" double lug

• For a permanent repair of a cast line, not thrust-proof
• Fully encompassing elastomer gasket seals transverse cracks and other damage to cast iron pipes
• Epoxy powder coated inside and outside

Easy and quick installation

1. The pipe must be cleaned in advance and any insulating layers have to be removed
2. Distance from the defective point to saddle edge min. 60 mm gap width of the pipe to be joined - max. 5 mm
3. In case of completely broken pipe ensure that the pipe is not subjected to tensile stress before connecting
4. Before assembly, loosen the screws to the maximum, whereby the nut is not removed from the screw
5. When installing the clamp, care shall be taken that the end of the gasket (1) that is closer to the pressure sheet (3) is located between the pipe (4) and the other end of the gasket (2). The rubber ends shall sufficiently overlap to ensure the sealing effect
6. We recommend positioning the clamp in such a way that the bolt heads are well accessible so they can be tightened properly. The nuts are fixed in the locating slots of the opposite segment
7. The bolts shall be tightened evenly (in alternating order)
8. The clamp can be used for one installation process. It´s not intended for reuse
9. After installation, please perform a leakage test while the trench is still open. The maximum operating pressure has to be complied with as a function of the medium and pipe outside diameter (see "Intended use").